+31 (0) 186 600 880

Otoflash G171N2 – Postcuring Unit with N2

This curing device provides an effective polymerization of light curing resins by means of intense flashes of light. The Otoflash has two flash lamps which radiate light from below into the polymerization chamber. Use the Otoflash for curing your objects manufactured by means of 3D Printing or rapid manufactoring.

Due to the technical configuration of the Otoflash G171, short curing times are possible. The flashlamps mentioned above produce 10 flashes of light per second which occur at a wavelength of 280-580nm. These can be called very intense. If you compare this with other methods (different light spectrum), the Otoflash achieves a significantly better curing of the materials which contributes to better physical characteristics and a reduced residual polymer content.

Optionally, the Otoflash can be equipped with a gas device connection (N2), which prevents any oxygen inhibition. As a result, the cured objects will not feel tacky and there is no need to remove the inhibition layer.

The polymerization chamber measures 120 x 120 x 50 mm. The total device is 310 x 310 x 140 mm and weighs 6 kg.


Type: Otoflash G171 with N2 availability
Unit: Post Cure unit for 3D DLP/SLA prints
Size inside tray: 120 x 120 x 50 mm
Size system: 310 x 140 mm
Weight: 6 kg

2.695,00 excl. VAT

Order your product directly

Need large armounts?

Accountmanager spreken?
In 3 simpele stappen een offerte aanvragen
Would you like to speak to an account manager?
Request a quote in 3 simple steps